Usage instruction:
1. Remove protection cap.
2. Clean electrode with distilled water and suck it with filter paper.
3. Turn pH on using "ON-OFF" located on the top of battery cover.
4. Immerge electrode of pH meter in solution to draught level. In no case, do not immerge above display level.
5. Stir gently and wait for reading to stabilize.
6. After usage, switch it off, use distilled water to clean electrode and place protective cap.
Important:
Device pH range must be recalibrated:
- Before every usage;
- When electrode has not been used for a long time from last calibration;
- If electorde has been used in particular tough conditions.
Am insulating my garage wall as it is attached to the entrance hall which is cold. The outside tap is in the garage and will be behind the insulation. Local plumbers merchants couldn’t help with a suitable part so managed to source a 50mm extender from here which was delivered promptly. Very good product and excellent service. Will use them again if needed and will recommend them.
This popular online store offers a wide range of high-quality products at reasonable prices, backed by efficient delivery and excellent customer service, ensuring a seamless shopping experience for its patrons....This popular online store offers a wide range of high-quality products at reasonable prices, backed by efficient delivery and excellent customer service, ensuring a seamless shopping experience for its patrons.
